1. Conditions of use

There are oil supply ports on the upper and lower sides of the VSL-KR double-line distributor. When the distributor piston moves forward and reverse, grease is discharged from the upper and lower oil supply ports respectively; there are two joints in the corresponding upper and lower oil supply ports. The oil discharge structure is one, and to change the odd-numbered oil discharge, just unscrew the screw in the hole. You can also directly observe the working condition of the distributor from the movement of the indicator rod. At the same time, you can also adjust the oil supply amount of each oil outlet within the specified range by adjusting the screw.

This type of distributor is suitable for dual-line dry oil centralized lubrication systems with a nominal pressure of 40MPa. Under the alternating oil supply pressure of the two oil supply main pipes, the oil supply pressure directly controls the piston movement to complete the oil supply.Process lubricationThe function of quantitatively distributing grease.

2. Technical parameters

3. Model marking instructions

4. Overall dimensions

5. Instructions for use

If you need to merge the upper and lower outlets accordingly, you only need to unscrew the compression plug in the upper oil outlet hole with a 6mm hexagonal wrench, take out the oil separator sleeve and insert it downward through the hole, then tighten the compression plug. At this time The upper outlet is blocked with a G1/4 screw plug to prevent dust intrusion.

6. Ordering Instructions

If the distributor is installed and used at an ambient temperature other than -10 to 80°C, it must be specified in the order contract so that low- and high-temperature resistant oil seals can be provided during supply.