1. Conditions of use

DB-N (ZB) series multi-point lubrication pump is suitable for low lubrication frequency and lubrication points below 50 points.Smart lubricationIn a single-line centralized lubrication system for small and medium-sized mechanical equipment with a nominal pressure of 31.5 MPa, grease is delivered to each intelligent lubrication point directly or through a single-line distributor.

Oil supply device.

This pump is suitable for metallurgy, mining, port, transportation, construction and other equipment.

2. Technical parameters

The medium used is grease with a cone penetration of not less than 265 (25°C, 150g) 1/10mm or lubricating oil with a viscosity grade greater than N68. The working environment temperature is -20 to 80°C.

3. Model description

4. Graphic symbols

5. Dimensions

6. Instructions for use

1. The multi-point lubrication pump should be installed in a place where the ambient temperature is suitable, there is little dust, and it is convenient for grease inspection, maintenance, etc.

2. To replenish grease into the oil reservoir, you must use a fuel pump to inject it from the filling port of the oil reservoir. It is strictly prohibited to open the cover and add unfiltered working medium.

3. Connect the motor according to the rotation direction specified on the rotation direction plate on the wall of the oil reservoir, and do not reverse it.

4. The number of oil supply ports can be selected arbitrarily within the range of 1 to 14. The unused plunger pump components can be removed by themselves according to the needs of the equipment. The screw holes can be blocked with M20×1.5 screw plugs.