1. Overview
ZB type multi-point lubrication pump is suitable for multi-line centralized lubrication systems of small and medium-sized mechanical equipment with low lubrication frequency, lubrication points below 50 points, and a nominal pressure of 31.5MPa. It supplies water to each lubrication point directly or through a single-line distributor. Grease delivery and oil supply device. It is especially suitable for stand-alone equipment such as metallurgy, mining, heavy machinery, and port transportation construction.
2. Technical parameters
The applicable medium is grease with a penetration of not less than 265 (25℃, 150g) 1/10mm and lubricating oil with a viscosity grade greater than N68; the applicable ambient temperature is -20~+80℃.
3. Model description
4. Action description
ZB type multi-point lubrication pump is mainly composed of oil reservoir, reduction mechanism, oil pressure plunger pump and electric motor.
The electric motor drives the worm and the worm gear to rotate at a reduced speed. The worm gear shaft drives the eccentric drive wheel to rotate at a low speed. The intercalary disk of the drive wheel drives the oil pressure plunger pump to perform reciprocating suction and pressure oil movement, so that the oil outlet of each pump element discharge to the outsideSmart lubricationagent.
5. Dimensions
6. Instructions for use
1. This type of multi-point lubrication pump should be installed in a place where the ambient temperature is suitable, there is little dust, and it is convenient for inspection, maintenance and grease replenishment.
2. To replenish grease into the oil reservoir, you must use a fuel pump to add it from the filling port of the oil reservoir. It is strictly prohibited to open the lid and add unfiltered media.
3. Connect the motor according to the rotation direction specified on the rotation direction plate on the wall of the oil reservoir, and do not reverse it.
4. The number of oil supply ports can be selected arbitrarily within the range of 1 to 14. The unused oil pressure plunger pump components can be removed by themselves according to the needs of the equipment. The screw holes can be blocked with M20×1.5 screw plugs.
5. To adjust the amount of oil supply, adjust the position of the screw sleeve in sequence 3 as shown below.
Address: No. 010, Xinglong Road, Huilong Industrial Park, Qidong City
Sales hotline: 0513-83637668
Company fax: 0513-83637098
After-sales service: 0513-83635700
Website: delcan.cn
E-mail:qd3637668@163.com
Scan to learn more